Table of Contents
Advertisement
Check the impeller clearance by sliding a feeler gauge through the
intake grate and measure the clearance between the impeller edge
and liner. If adjustment is required, refer to Impeller Removal and
Installation.
Compressor Air Intake Filter
The filter should be changed every 100 hours of operation, or once
a season.
IMPORTANT: Never run the engine without the air filter.
REMOVAL
1. Remove three screws and filter cover from engine.
2. Remove filter from the cover.
a -
Cover
INSTALLATION
1. Install filter into cover.
2. Fasten filter cover with three screws.
Alternator Belt Inspection
Inspecting the belts with the engine running may cause serious
injury or death. Turn off the engine and remove the ignition key
before adjusting tension or inspecting belts.
1. Inspect the alternator belt and have it replaced by an
authorized dealer if any of the following conditions are found.
MAINTENANCE
WARNING
!
75
b
a
29476
b -
Filter
Advertisement
Table of Contents
