Engine Oil Level Check - Segway Villain SX10 Owner's Manual

Engine Oil Level Check

Running the engine with an improper oil level can cause
1. Park the vehicle on a level ground.
2. Remove the rear cargo bed.
3. Start the vehicle and let the engine idle for 5 minute，stand for 30 seconds.
4. Using a rag hold the end of the oil dipstick, and remove the oil dipstick from the
engine.
5. Wipe the oil from the dipstick.
6. Reinsert the dipstick completely.
7. Pull the dipstick out and check the oil level.
Check the oil level as shown in the figure below. If the oil level is between the upper
1
engraved line and the lower engraved line
the lower scale means the oil is too low, and the upper scale means the oil is too
full, too low or to full is not recommended.
1
Upper Engraved Line
8. After cleaning the oil dipstick, insert and install it again.
9. If the oil level is near or below the lower level mark.
• Removal of rear cargo bed (see page 4-5) .
• Remove the oil fill cap
• Add the specified oil into the fill cap hole, up to the upper level mark on the
dipstick.
• Reinstall the oil fill cap and dipstick.
NOTICE NOTICE
serious engine damage.
2
, it is the proper oil level. Below
2
Lower Engraved Line
3
from the front right crankcase cover
4-8
3
Oil Filler Cap