Standby Mode (Pwr+Stbm); Wireless Network (Ntw) - Christie G Series Application Manual

Standby Mode (PWR+STBM)

Use this command to place the projector in standby mode.
Subcode
Subcode
STBM
Read/Write
Yes
Examples
Command
(PWR+STBM0):0.5W mode
(PWR+STBM1):Communication

Wireless Network (NTW)

Use this command to modify the wireless network settings.
Subcode
Subcode
SLCT
ETH0
SUB0
GATE
MAC0
Read/Write
Yes
G Series Serial Commands Application Guide
020-000578-02 Rev. 1 (01-2014)
Places the projector in standby mode.
Use and to select next and previous values.
n p
Places the projector in 0.5W mode. In this mode, the projector consumes less
than 0.5W and only the keypad receives power. The projector cannot be
started by selecting UART > WEB > USB.
Places the projector in communication mode. In this mode, the projector
consumes 20W and the keypad, remote, and wired and wireless connections
remain active. The projector can be started by selecting UART > WEB > USB.
Turns wireless LAN on or off.
Modifies the IP address.
Modifies the subnet mask.
Modifies the default gateway.
Modifies the MAC address.
Description
Description
Description
Commands
45