Table of Contents
Advertisement
Lamp Mode (LPM)
Use this command to apply different lamp modes.
Subcode
None
Read/Write
Yes
Examples
Command
(LPM0)
(LPM1)
(LPM2)
Lamp Power (LPP)
Use this command to set the lamp power. For DHD550-G and DWU550-G projectors, the power
range is 280 to 370W. For DWX600-G, DHD600-G, and DWU600-G projectors, the power range is
360 to 465W.
Subcode
None
Read/Write
Yes
Examples
Command
(LPP360)
Light Sensor Calibration (LLC)
Use this command to calibrate the light sensor. Complete a calibration whenever the lamp is
replaced.
G Series Serial Commands Application Guide
020-000578-02 Rev. 1 (01-2014)
Sets the lamp to constant power. The power value must be set with the Lamp Power
command.
Sets the lamp to constant intensity mode. The intensity value must be set with the
Lamp Intensity command.
You cannot apply this mode if the light sensor has not been calibrated.
Sets the lamp to ECO mode. The fan speed operates at its lowest setting and lamp
power is adjusted to its minimum setting.
Sets lamp power to 360W.
Description
Description
Commands
48
Advertisement
Table of Contents
