Setting Up Password Protection; Changing Password; Setting Up Power Mode; Setting The Standby Mode - Christie GS 2K Series User Manual

Setting up password protection

Protect your projector with a password. Once enabled, you must enter the password before you can
project an image.
1. Select Menu > Configuration > Menu Preferences > PIN Protect.
2. Enter a password by number keys.
3. To confirm the password, select OK.

Changing password

Change the current password to a new password.
1. Select Menu > Configuration > Menu Preferences > Change PIN.
2. Enter current password by number keys.
3. Select OK.
4. Enter new password by number keys.
5. Select OK.
6. To confirm the password, enter new password again by number keys.
7. Select OK.

Setting up power mode

Adjust various projector's power settings including the shutdown time, sleep timer, and standby
mode.

Setting the standby mode

Determine which standby mode the projector is in when AC power on.
1. Select Menu > Configuration > Power Management > Standby Mode.
2. Select the appropriate mode:
• 0.5W mode—Less power consumption which does not have the ability to monitor the
projector over a network cable in standby mode.
• Communication mode—More power consumption in standby mode which allows you to
monitor the projector over a network cable.
3. Press ENTER.
Communication mode is the projector's default standby mode. After performing factory reset,
manually set the standby mode to 0.5W mode to have less power consumption (<0.5W).
GS Series 2K User Manual - DWU880-GS, DWU880A-GS, DWU9200-GS, DWU1100-GS, DWU1100A-GS
020-001908-01 Rev. 1 (02-2022)
Copyright © 2022 Christie Digital Systems USA Inc. All rights reserved.
Configuring system settings
52