Over Scan (Ovs); Pixel Phase (Pxp); Pincushion/Barrel (Pcb) - Christie G Series Application Manual

Over Scan (OVS)

Use this command to modify how the input image edges are framed and remove noise from around
the image.
Subcode
None. Use n and p to select next and previous values.
Read/Write
Yes
Examples
Command
(OVS0):OFF
(OVS1):ZOOM
(OVS2):CROP

Pixel Phase (PXP)

Use this command to adjust the pixel clock phase for analog inputs. The adjustment range is 0 to
100 and the default value is 50.
Subcode
None
Read/Write
Yes
Examples
Command
(PXP50)

Pincushion/Barrel (PCB)

Use this command to correct curved distortion caused by the lens or the projection surface. This
command is not available if a Dual Processor Warp Module (DPWM) is not installed.
G Series Serial Commands Application Guide
020-000578-02 Rev. 1 (01-2014)
Sets the pixel phase to 50.
Description
Description
Commands
12