Commands
Digital Vertical Zoom (DZV)
Use this command to change the size of projector vertical display area. If the display area has been
resized with this setting, use the Digital Horizontal Shift and Digital Vertical Shift commands to
readjust the image. The adjustment range is 50% to 400% and the default value is 100%.
Subcode
None
Read/Write
Yes
Examples
Command
Description
(DZV100)
Four Corner Geometry Correction (CNR)
Use this command to fit an image in an area defined by x and y coordinates. This command is not
available if a Dual Processor Warp Module (DPWM) is not installed.
The horizontal adjustment range is 0 to 190 and the vertical adjustment range is 0 to 100. The
default value for both adjustments is 0.
This image illustrates the maximum adjustment range:
G Series Serial Commands Application Guide
8
020-000578-02 Rev. 1 (01-2014)