Setting Up Power Mode; Setting The Standby Mode; Setting The Ac Power; Setting The Time For Auto Shutdown - Christie Inspire Series User Manual

Setting up power mode

Adjust various projector's power settings including the shutdown time, sleep timer, and standby
mode.

Setting the standby mode

Determine which standby mode the projector is in when AC power on.
Communication mode is the projector's default standby mode. After performing factory reset,
manually set the standby mode to 0.5W mode to have less power consumption (<0.5W).
1. Select Menu > Configuration > Power Management > Standby Mode.
2. Select the appropriate mode:
• 0.5W mode—Less power consumption (<0.5W) which does not have the ability to
monitor the projector over a network cable.
• Communication mode—More power consumption in standby mode which allows you to
monitor the projector over a network cable.
3. Select ENTER.

Setting the AC power

Enable or disable this function to power on the projector directly or not when AC power is on.
1. Select Menu > Configuration > Power Management > AC Power On.
2. To swap, select ENTER.

Setting the time for auto shutdown

Set up a time for automatically turns off the projector after no signal is detected for a preset
number of minutes. If an active signal is received before the projector powers down, the image is
displayed.
1. Select Menu > Configuration > Power Management > Auto Shutdown.
2. Select the appropriate time to automatically turn off the projector when no signal exists.
3. To confirm the selection, select ENTER.

Setting the sleep timer

Set up a time for automatically power off the projector, after it has been on for a specified amount
of time.
1. Select Menu > Configuration > Power Management > Sleep Timer.
2. Select the appropriate time to automatically turn off the projector.
3. To confirm the selection, select ENTER.
Inspire Series 4K User Manual
020-002098-01 Rev. 1 (09-2023)
Copyright © 2023 Christie Digital Systems USA Inc. All rights reserved.
If printed, please recycle this document after use.
Configuring system settings
55