Table of Contents
Advertisement
Rotation Geometry Correction (ROT)
Use this command to rotate and level an image. When an image is rotated, content falling outside
of the display area is cropped. To prevent cropping the image is not automatically scaled down. If
scaling is required, use the digital zoom function.
This command is not available if a Dual Processor Warp Module (DPWM) is not installed.
The adjustment range is 0 to 20 and the default value is 10.
This image illustrates the maximum adjustment range:
Subcode
None
Read/Write
Write only
Examples
Command
(ROT1)
Size Presets (SZP)
Use this command to:
•
Display an image with the default size.
•
Resize an image by maximizing the height, width, or both.
•
Resize an image to the maximum size and maintain the original aspect ratio.
Subcode
None. Use n and p to select next and previous values.
Read/Write
Yes
G Series Serial Commands Application Guide
020-000578-02 Rev. 1 (01-2014)
Sets the rotation correction value to 1.
Description
Commands
14
Advertisement
Table of Contents
