Finding A Remedy - Stratasys Fortus 360mc User Manual

Finding a Remedy

Condition
Canister will not
load
Possible Cause
Anti-rotation plug not
removed from canister.
Rubber thumbwheel insert
not removed from thumb-
wheel door.
Empty canister (zero vol-
ume)
Filament stuck in canister.
Canister drive block not
fully lowered onto canis-
ter.
Wrong tip size selected on
operator display.
Canister smartspool circuit
failed.
Broken or bent pogo pin.
Filament does not reach
head (load time-out
reached).
8-2
Remedy
Remove plug.
Remove thumbwheel insert.
Replace canister.
Remove canister from system and
pull out about eight feet (two
meters) of material out. Ensure fil-
ament pulls out freely.
Reset drive block onto canister.
Verify correct tip size on display.
See "Liquefier Tips" on page
View Filament Status from opera-
tor display. If the status reads
None or is blank, replace the can-
ister.
Remove canister from bay and
check pogo pins on underside of
the canister drive block. Replace
any bent or broken pogo pins.
Install a new canister. If this fails,
call Customer Support.
3-9.