Moving The System - Stratasys Fortus 360mc User Manual

Moving the System

If you need to move the system to a different location, a specific sequence of steps
must be followed.
1.
Unload material filament from the liquefiers.
the Liquefier Tips" on page
2.
Remove the material canisters. See
3.
Lower the Z stage to the bottom of its travel. See
Bottom of Travel." on page
4.
Shut down power to the system. See
4.
Warning: Due to the UPS, High voltage is present in the
system with the power cord unplugged.
Caution: Before unplugging the system always make sure the
oven is cool to avoid blowing the oven thermal cut-out fuses.
5.
Unplug the power cable from the power source.
6.
Secure the Z stage:
A.
B.
C.
Remove all side panels on the system.
Grasp the Z stage drive belt and the lower Z stage until the end plates rest
on the lower hard stops.
On the left and right side of the system, wrap a large wire tie around the
end plate and the lower bearing mount plate, see
• Make sure the wire tie is tight.
Figure 2-5: Securing the Z Stage
See"Unloading Material from
4-13.
"Removing Canisters" on page
4-36.
"Powering Down the System" on page 4-
2-5
4-14.
"Moving the Z Stage to
Figure 2-5.
End Plate
Tie Wrap
Bearing Mount
Plate