Placing System In Receive Software Upgrade Mode; Maintenance Schedule - Stratasys Fortus 360mc User Manual

Placing System in Receive Software Upgrade
Mode
Place the system in software upgrade mode by doing the following:
1.
Place the modeler in the Upgrade mode (Maintenance > Administration >
Receive Software Upgrade or Code).
• The operator panel will display the following message.
>Waiting for Software Upgrade or Code
Press MENU key to Cancel
2.
The system is now in the receive software upgrade mode.

Maintenance Schedule

Maintenance tasks must be performed on a regular basis in order to maintain
optimal system operation.
Detailed instructions for each task make up the rest of this chapter.
Warning:
removing any of the access panels.
Warning: Due to the UPS, High voltage is present in the
system when the power cord is unplugged.
Warning: Always wear proper heat protective clothing when
working inside the oven.
Daily Weekly Quarterly
X
X
X
X
Table 7-1
Always power down and unplug the system before
Table 7-1: Maintenance Schedule
"Clean the Platen" on page 7-4
"Empty the Purge Waste Bucket" on page 7-4
"Vacuum the Build Envelope" on page 7-5
"Clean/Inspect Tip Wipe Assembly" on page 7-5
"Inspect the Platen O-Ring" on page 7-8
X
"Clean the Vacuum System In-Line Filter and
X
Jar" on page 7-8
"Clean the Tip Sensor Plunger" on page 7-9
X
outlines the general maintenance schedule.
Maintenance Task
7-3