Liquefier Tips; Liquefier Tips And Slice Heights; Tip Compatibility & Selection - Stratasys Fortus 360mc User Manual

Liquefier Tips

Liquefier Tips and Slice Heights

Two types of liquefier tips are available. Standard tip tips are used for all
modeling materials and for Break-Away Supports (BASS) materials and soluble
tips are used for soluble support materials. When modeling with materials that
use soluble release support material (SR), use the T12SR20, T12SR30, or T12SR100
tip for the support material.
• There are seven tips available: T10, T12, T12SR20, T12SR30, T12SR100, T16,
and T20.
• Tips are a replaceable consumable item. To change tips, see
or Material Type" on page
• Tips must be changed when the material type is changed.
Tip Compatibility & Selection
Table 3-2
Table 3-3
Table 3-4
used.
• The system tracks tip use and automatically prompts you, through the user
interface, when a tip should be replaced. Worn tips are prone to clogs and
reduce part quality. See
information on viewing tip use status.
• When changing tips, the system will guide you through resetting the tip
odometers from the display panel.
• If building with ABS-M30/M30i, you can use either SR-20 or SR-30
• If building with ABS-ESD7, you can use SR-30.
• If using SR-20 material, use T12SR20 tip only (previously called a T12SR
• If using SR-30 material, use T12SR30 tip only.
• If using SR-100 material, use T12SR100 tip only.
• If using SR-110 material, use T12SR100 tip only.
The standard tip is used for Break-Away Supports (BASS) and model material.
See "Tip Identification" on page 3-12
shows the available material and tips.
lists the slice heights for the three model tips.
provides approximate Tip Life - based upon the amount of material
support material.
tip).
4-22.
"Odometer Status" on page 4-32
for more information.
3-9
"Changing Tips
for more