Table of Contents
Advertisement
10. Technical Specifications
Unless otherwise specified, the technical specifications applied are for the oscilloscopes only,
and Probes attenuation set as 10X. Only if the oscilloscope fulfills the following two conditions
at first, these specification standards can be reached.
◼ This instrument should run for at least 30 minutes continuously under the
specified operating temperature.
◼ If change of the operating temperature is up to or exceeds 5℃, do a
"Self-calibration" procedure (see "How to Implement Self-calibration" on
P15).
All specification standards can be fulfilled, except one(s) marked with the word
"Typical".
Oscilloscope
Performance Characteristics
Bandwidth
Vertical Resolution (A/D)
Channel
Waveform Capture Rate
Multi-level Gray Scale Display &
Color Temperature Display
(Use gray scale to indicate frequency of
occurrence, where frequently occurring
waveform are bright.)
Mode
Acquisition
Sample rate
(real time)
Input coupling
Input impedance
Input
Input coupling
Max input voltage
Bandwidth limit
10.Technical Specifications
XDS4504
XDS4502
XDS4354
XDS4352
8 bits
XDS4502
XDS4352
XDS4504
XDS4354
600,000 wfms/s
Support
Normal, Peak detect, Averaging
Four CH
Dual CH*
Single CH 5 GSa/s
DC, AC , Ground
1 MΩ±2%, in parallel with 15 pF±5 pF,
50Ω±2%
0.001X - 1000X, step by 1 – 2 - 5
400 V (DC + AC Peak)
20 MHz, full bandwidth
130
Instruction
500 MHz
350 MHz
2
4
1 GSa/s
2.5 GSa/s
Advertisement
Table of Contents
