Owon XDS4000 Series User Manual page 48

Mode
Holdoff
4. Slope Trigger
Slope trigger sets the oscilloscope as the positive/negative slope trigger within
the specified time.
In Slope Trigger mode, the trigger setting information is displayed on bottom
right of the screen, for example,
type is slope, trigger source is CH1, slope is rising, 0.00mV is the differential
between up level and low level threshold.
Slope trigger menu list:
MENU SETTING
Single
Slope
Mode
CH1
CH2
Source
CH3
CH4
slope
When
Slew rate
High level
Threshold
Low level
&SlewRate
Slew rate
4.Advanced User Guidebook
Auto Acquire waveform even no trigger occurred
Normal Acquire waveform when trigger occurred
Single When trigger occurs, acquire one waveform then
stop
Holdoff
100 ns - 10 s, adjust M knob or click
time interval before another trigger occur, press
cursor to choose which digit to be set.
INSTRUCTION
Set vertical channel trigger type as slope trigger.
Select CH1 as the trigger source
Select CH2 as the trigger source
Select CH3 as the trigger source
Select CH4 as the trigger source
Slope selecting
Set slope condition; turn the M knob or click
to set slope time, press
click
digit to be set.
Slew rate = (High level - Low level) / Settings
Adjust M knob to set the High level upper limit.
Adjust M knob to set Low level lower limit.
Slew rate = (High level - Low level) / Settings
panel button or click
, indicates that trigger
to move cursor to choose which
42
to set
to move
panel button or