Table of Contents
Advertisement
sample point, and signal rate of the CAN signal.
In CAN bus trigger mode, the trigger setting information is displayed on
bottom right of the screen, for example,
that trigger type is CAN, CH1 trigger level is -126 mV.
CAN Trigger menu list:
MENU
SETTING
Bus
CAN
Type
Source
Type
Sample
Input
Point
Common
Baud
Custom
Baud
Start
Conditio
n
Type
4.Advanced User Guidebook
INSTRUCTION
Set vertical channel bus type as CAN trigger.
CH1
Select CH1 as the trigger source.
CH2
Select CH2 as the trigger source.
CH3
Select CH3 as the trigger source.
CH4
Select CH4 as the trigger source.
Actual CAN_H bus signal.
CAN_H
Actual CAN_L bus signal.
CAN_L
Transmission signal on the CAN signal
TX
line.
RX
Received signal on the CAN signal line.
Turn the M knob (or tap on
set the Sample point, which is a point within a bit's
time. The oscilloscope samples the bit level at this
point. "Sample point" is represented by the
percentage of "the time from the start of the bit's time
to the sample point time" in the "bit's time". The
range is 5% to 95%.
Turn the M knob to select from the Baud list on the
left.
Turn the M knob (or tap on
set the Baud. The range is 10,000 to 1,000,000.
Tip: You can select the nearest value in Common
Baud, and then adjust it in this menu.
Trigger on the start frame of the data frame.
Data
Remote
Type
(Bottom
Error
menu)
Overloa
d
54
in touchscreen) to
in touchscreen) to
Trigger
on
the
frame.
, indicates
selected
Advertisement
Table of Contents
