Technical Specifications - Owon TDS7074 User Manual

9. Technical Specifications

Unless otherwise specified, the technical specifications applied are for TDS series
only, and Probes attenuation set as 10X. Only if the oscilloscope fulfills the following
two conditions at first, these specification standards can be reached.
 This instrument should run for at least 30 minutes continuously under the
specified operating temperature.
 If change of the operating temperature is up to or exceeds 5℃, do a
"Self-calibration" procedure (see "How to Implement Self-calibration" on P14).
All specification standards can be fulfilled, except one(s) marked with the word
"Typical".
Performance Characteristics
Bandwidth
Channel
Acquisition
Input
9.Technical Specifications
Mode
Waveform Capture
rate
Max Sample rate
(real time)
Input coupling
Input impedance
Probe attenuation
factor
Instruction
TDS7074
TDS7104
TDS8104
TDS8204
TDS8304
TDS9304
Normal, Peak detect, Averaging
Four CH
TDS7074
Dual CH
TDS7104
Single CH
Four CH
TDS8104
Dual CH
TDS8204
Single CH
Four CH
TDS8304 Dual CH
Single CH
Four CH
TDS9304 Dual CH
Single CH
DC, AC , Ground
1 MΩ ± 2%, in parallel with 10 pF ± 5 pF
50 Ω ± 1%
1X, 10X, 100X, 1000X
73
70 MHz
100 MHz
100 MHz
200 MHz
300 MHz
300 MHz
4
50,000
500MS/s
1GS/s*
1GS/s
1GS/s
2GS/s*
2GS/s
1.25GS/s
2.5GS/s*
2.5GS/s
1.6GS/s
3.2GS/s*
3.2GS/s