Table of Contents
Advertisement
Average
Refresh
Rate
The description of the Record Length menu is shown as follows:
Function Menu
Length
The description of the Intrpl menu is shown as follows:
Function Menu
Intrpl
Interpolation method is a processing method to connect the sampled points,
using some points to calculate the whole appearance of the waveform. Select
the appropriate interpolation method according to the actual signal.
Sine(x)/x interpolation: Connect the sampled points with curved lines.
Linear interpolation: Connect the sampled points with straight lines. This
method is suitable to rebuild the straight-edged signals, such as square or
pulse wave.
4.Advanced User Guidebook
It is used to reduce the random and
4,
16,
64,
don't-care noises, with the optional
128
number of averages.
Set the waveform refresh rate, you can
□ Low
turn on this mode when you need to
observe a single waveform.
Setting
Description
1K
Choose the record length
10K
Note: When
100K
on, the max record length is 100M;
1M
max
10M
（Need to meet either condition:
100M
CH1&CH3 on, CH2&CH4 off;
200M
CH2&CH4 on, CH1&CH3 off. ） ; max
400M
400M for one channel.
Setting
Description
Sinx/x
Use sine(x)/x interpolation
x
Use linear interpolation
61
four channels are turned
200M
for
two
and
channels
Advertisement
Table of Contents
