Section 1: General Information; Introduction; Accessories Supplied; Technical Specifications - Owon SDS Series Service Manual

Section 1: General Information

1.1 Introduction

This service manual contains information on adjusting and servicing the SDS Series
Oscilloscope.
Chapter General Information simply introduces the specifications of the oscilloscope.
Chapter Installation introduces the theory of installing.
Chapter Test and Calibration simply introduces some theory and method of tests.
Chapter Debugging and Calibration supplies some modules for adjust and some
methods.
Chapter Maintenance mainly supplies some parts to customers for service
Chapter Replaceable Parts mainly introduces theories and methods of servicing.

1.2 Accessories Supplied

Standard Accessories:
2 Passive probe: 1.2 m, 1:1 (10:1)
CD: x 1 (PC link application software)
Power cord: 1pcs, up to the standards of the country in which it is used.
USB cable
User Manual: 1pcs
Options:
Battery

1.3 Technical Specifications

Unless otherwise specified, the technical specifications applied are applicable to
the probe with the attenuation switch setting 10X and the SDS series digital
oscilloscope. Only if the oscilloscope fulfill the following two conditions at first,
can these specification standards be reached.
This instrument should run for more than 30 minutes continuously under the
specified operating temperature.
If the change range of the operating temperature is up to or exceeds 5 ,
open the system function menu and execute the "Auto-calibration" procedure
(see "4.4 Auto-calibration" on P18).
All specification standards can be fulfilled, except one(s) marked with the word
"Typical".
Section 1: General Information
1
℃