Owon XDS4000 Series User Manual page 73

When the type is Configure, the menu shows as following:
Configure
Save
Load
When the type is Image, the menu shows as following:
Save
Save and Recall the Waveform
The oscilloscope can store 100 waveforms, which can be displayed with the
current waveform at the same time. The stored waveform called out can not be
adjusted.
In order to save the waveform of CH1, CH2 and Math into the address 1, the
operation steps should be followed:
1. Turn on CH1, CH2 and Math channels.
2. Push the Save button.
3. Saving: Select Type in the bottom menu, select Wave in the left menu.
4. Select Storage in the bottom menu, select Internal in the right menu.
5. Select Source in the bottom menu, check CH1, CH2, Math in the right
menu for Source.
6. Select Object & Show in the bottom menu, select Wave1 as object
address in the left menu.
7. Select Save in the bottom menu to save the waveform.
8. Recalling: Select Object & Show in the bottom menu, select Wave1 in
the left menu. In the right menu, select Show as ON, the waveform stored
in the address will be shown, the address number and relevant information
will be displayed at the top left of the screen.
In order to save the waveform of CH1 and CH2 into the USB storage as a BIN
file, the operation steps should be followed:
4.Advanced User Guidebook
Setting0
.....
The setting address
Setting19
Save the current oscilloscope configure
to the internal storage
Recall the configure from the selected
address
Save the current display screen. The
file can be only stored in a USB
storage, so a USB storage must be
connected first. The file name is
editable. The file is stored in BMP
format.
67