Technical Specifications - Owon AS Series User Manual

5. Technical Specifications

Unless otherwise specified, the technical specifications applied are for
single-channel series only, and Probes attenuation set as 10X. Only if the
oscilloscope fulfills the following condition at first, these specification standards
can be reached.
 This instrument should run for at least 30 minutes continuously under the
specified operating temperature.
All specification standards can be fulfilled, except one(s) marked with the word
"Typical".
Performance Characteristics
Bandwidth
Channel Q'nty
Run/Stop
Acquisition
Sampling Rate
Input Coupling
Input Input Impedance
Max. Input Voltage
Sampling Rate Range
Interpolation
Horizontal Scanning Speed (s/DIV)
System
Sampling Rate / Relay
Time Accuracy
Trimming Ratio
Sensitivity
Displacement
Analog Bandwidth
Vertical
system
Low Frequency
Rise Time
(at input, typical)
Trimming Ratio
X-Y Mode
Sensitivity
Bandwidth (-3dB)
Trigger
Trigger Level Range
Trigger Level Accuracy
(typical)
5.Technical Specifications
AS101
AS201
1
supported
100M Sa/s
DC, AC, and ground
1 MΩ ± 2%, in parallel with 20 pF±5 pF
400V (DC+AC, PK - PK)
0.5 Sa/s - 100 MSa/s
sin(x)/x
0.05μs/DIV - 0.1s/DIV, step by 1 - 2 - 5
±100 ppm
≥ 2.5:1
5 mV/DIV - 10 V/DIV
±10 DIV
AS101
AS201
≥ 10 Hz (at input, AC coupling, -3 dB)
≤ 30 ns
≥ 2.5:1
X: 0.5V/DIV, Y: 0.1V/DIV - 1V/DIV
DC: 0 - 1MHz, AC: 10Hz - 1MHz
Internal ±4 DIV from the screen center
Internal,
±0.3 DIV
External
13
Instruction
DC 0 – 10 MHz
AC 10 Hz – 10 MHz
DC 0 – 20 MHz
AC 10 Hz – 20 MHz
10 MHz
20 MHz