How To Use Autoscale - Owon XDS4000 Series User Manual

to move line b.
6. In the bottom menu, select Line Type as Vamp to make the horizontal
cursors active. Select Line in the bottom menu as a or b, turn the M
knob to move it.
7. In the bottom cursor menu, you can select Window as Main to make
the cursors shown in the main window.

How to Use Autoscale

This is a very useful function for first time users to carry out a simple and quick
test on the input signal. The function is applied to follow-up signals
automatically even if the signals change at any time. Autoscale enables the
instrument to set up trigger mode, voltage division and time scale automatically
according to the type, amplitude and frequency of the signals.
The menu is as follows:
Function
Menu
Autoscale
Mode
Wave
To measure the signal using autoscale, you can do as the follows:
1. Push the Autoscale button, the function menu will appear.
2. In the bottom menu, select ON in the Autoscale menu item.
3. In the bottom menu, Select Mode. In the right menu, select
4. In the bottom menu, Select Wave. In the right menu, select
Then the wave is displayed in the screen, shown as Figure 4-28.
4.Advanced User Guidebook
Setting
ON Turn on
OFF Turn off
Follow-up and adjust both vertical and horizontal
settings.
Follow-up and only adjust horizontal scale.
Follow-up and only adjust vertical scale.
Show Multi-period waveforms.
Only show one or two periods.
Instruction
Autoscale.
Autoscale.
95
.
.