Table of Contents
Advertisement
oscilloscope and the red test lead to the
(3) Probe the test points and read the display.
Testing Diodes
(1) Push DMM button on the front panel. Select
it until switching to
(2) Connect the black test lead to the COM terminal on the back of the
oscilloscope and the red test lead to the
(3) Connect the red test lead to the positive terminal (anode) of the diode and the
black test lead to the negative terminal (cathode). The cathode of a diode is
indicated with a band. Read the diode forward bias.
Testing for Continuity
(1) Push DMM button on the front panel. Select
it until switching to
(2) Connect the black test lead to the COM terminal on the back of the
oscilloscope and the red test lead to the
(3) Probe the test points to measure the resistance in the circuit. If the reading is
below 50 , the multimeter will beep.
Measuring Capacitance
(1) Push DMM button on the front panel. Select
it until switching to C.
(2) Insert the supplied capacitance measurer to the COM terminal and the
terminal on the back of the oscilloscope.
(3) Insert the capacitance to the capacitance measurer, then screen shows the
capacitance reading.
Note: when measuring the capacitance which is less than 5 nF, please use relative
value measuring mode to improve measuring precision.
Multimeter Features
Data Hold Mode
You can freeze the display for any function.
(1) Select Hold in the bottom menu as ON.
(2) Select OFF to exit this mode.
6.Use the Multimeter (Optional)
.
.
HOLD
112
terminal.
in the bottom menu, select
terminal.
in the bottom menu, select
terminal.
in the bottom menu, select
will be shown on the display.
Advertisement
Table of Contents
