Table of Contents
Advertisement
To Set Signals
(1) Push
button to show the bottom menu of generator.
(2) Select the desired waveform in the bottom menu, the corresponding menu is
displayed on the right.
(3) The parameters can be set in the right menu.
To Output Sine Signals
The parameters of Sine waveform in the right menu are: Frequency/Period, Start
Phase, Amplitude/High Level, Offset/Low Level.
To Set the Frequency
Select Frequency in the right menu (if Frequency is not displayed, select Period
and push it again to switch to Frequency). Set the parameter in the right menu,
see below.
Three methods to change the chosen parameter:
⚫ Turn
the
M
Press
/
⚫ Use the input keyboard: Push the M knob, an input keyboard will pop up.
Turn the M knob to move between the keys. Push the M knob to input the
chosen key.
5.Use the Arbitrary Function Generator
knob
to
change
direction key to move the cursor.
Clear
OK
101
the
value
of
Units
cursor
position.
Advertisement
Table of Contents
