Table of Contents
Advertisement
Area
: The area of the whole waveform within the screen and the
unit is voltage-second. The area measured above the zero reference
(namely the vertical offset) is positive; the area measured below the zero
reference is negative. The area measured is the algebraic sum of the area
of the whole waveform within the screen.
Cycle Area
and the unit is voltage-second. The area above the zero reference (namely
the vertical offset) is positive and the area below the zero reference is
negative. The area measured is the algebraic sum of the area of the whole
period waveform.
Note: When the waveform on the screen is less than a period, the period
area measured is 0.
How to customize an automatic measurement
You can customize automatic measurements by using gating and statistics.
Gating
⚫ Press the Measure button, and the automatic measurement function menu
is displayed at the bottom of the screen;
⚫ Press the Set softkey at the bottom of the screen, the setting menu
appears on the right side of the screen;
⚫ Select the Gating menu. There are two menus: Screen and Cursor under
the range. Click the Screen and then click the Cursor, or press the right
Screen menu button twice to set the cursor range.
Statistics
Select Statistics, you can choose On or Off to enable or disable statistics on
the measurement value.
Statistics reset: Restart statistics on statistics.
How to Measure with Cursors
Push the Cursor button to turn cursors on and display the cursor menu.
Push it again to turn cursors off.
The Cursor Measurement for normal mode:
The description of the cursor menu is shown as the following table:
Function
Setting
Menu
Voltage
Time
Time&Voltag
Type
AutoCursr
4.Advanced User Guidebook
: The area of the first period of waveform on the screen
Description
Display the voltage measurement cursor and
menu.
Display the time measurement cursor and
e
menu.
Display the time and voltage measurement
cursor and menu.
91
Advertisement
Table of Contents
