Table of Contents
Advertisement
Making Relative Measurements
When making relative measurements, reading is the difference between a stored
reference value and the input signal.
(1) Select Configure in the bottom menu, select Relative in the right menu to
enter the relative mode.
The measurement value at this time is stored as the reference value, and
displayed behind △.
In this mode, current reading = input value - reference value.
(2) Press it again to exit the mode.
Note: This function is not available when measuring resistance, diodes, and
testing for continuity.
Information Display
Show/hide the information window on the top right of the display.
(1) Select Configure in the bottom menu, select Show Info in the right menu as
ON. The information window will be shown on the display.
(2) Select OFF to hide.
Auto or Manual Range
Auto range is set as default. To switch auto or manual range, do the following
steps:
(1) Select Configure in the bottom menu.
(2) Select Auto Range in the right menu,
(3) Select Switch Range in the right menu, MANUAL will be shown on the display.
Press this softkey to switch range.
Note: When testing diode, testing continuity, and measuring capacitance, manual
range is disabled.
Multimeter Recorder
You can use the multimeter data recorder to record the measurements when
measuring current/voltage by multimeter (optional).
Push the Utility button, select Function in the bottom menu, select DAQ in the left
menu.
The description of DAQ Menu is shown as the follows:
6.Use the Multimeter (Optional)
AUTO
113
will be shown on the display.
Advertisement
Table of Contents
