Technical Specifications - Owon SDS5052E-V User Manual

9. Technical Specifications

Unless otherwise specified, the technical specifications applied are for SDS-E only,
and Probes attenuation set as 10X. Only if the oscilloscope fulfills the following two
conditions at first, these specification standards can be reached.
 This instrument should run for at least 30 minutes continuously under the
specified operating temperature.
 If change of the operating temperature is up to or exceeds 5℃, do a
"Self-calibration" procedure (see "How to Implement Self-calibration" on P15).
All specification standards can be fulfilled, except one(s) marked with the word
"Typical".
Performance Characteristics
Bandwidth
Channel
Acquisition
Input
9.Technical Specifications
SDS5032E(V)
SDS5052E(V)
SDS6062E(V)
SDS7072E(V)
SDS7102E(V)
SDS7122E(V)
Mode
SDS5032E(V)
SDS5052E(V)
SDS6062E(V)
Sample rate
(real time)
SDS7072E(V)
SDS7102E(V)
SDS7122E(V)
Input coupling
SDS5032E(V)
SDS5052E(V)
SDS6062E(V)
Input impedance
SDS7072E(V)
SDS7102E(V)
SDS7122E(V)
Probe attenuation
factor
Instruction
2 + 1 (External)
Normal, Peak detect, Averaging
Dual CH
Single CH
Dual CH
Single CH
Dual CH
Single CH
Dual CH
Single CH
Dual CH
Single CH
Dual CH
Single CH
DC, AC , Ground
1 MΩ ± 2%, in parallel with
10 pF ± 5 pF
1 MΩ ± 2%, in parallel with
15 pF ± 3 pF
1X, 10X, 100X, 1000X
95
30 MHz
50 MHz
60 MHz
70 MHz
100 MHz
125 MHz
250MS/s
500MS/s
250MS/s
500MS/s
250MS/s
500MS/s
500MS/s
1 GS /s
500MS/s
1 GS /s
500MS/s
1 GS /s