Table of Contents
Advertisement
a
b
ab
x
Line
Clone
(When the
generator is
available)
Save
Storage
Save
Output
The following steps take the oscilloscope with waveform generator for
4.Advanced User Guidebook
Turn the M knob to move line a.
Turn the M knob to move line b.
Two cursors are linked. Turn the M knob to move
the pair of cursors.
Set the cursors to select the entire screen
automatically.
The waveform information is displayed at the left
bottom corner of the screen.
Note: If "Out Of Limits" appears in the information
or a message "Waveform points beyond the
limit." appears on the screen, that means the length
of the cloned waveform exceeds the limit. In source
mode the maximum length is 2M. Push the Acquire
button, select Length in the bottom menu, and set
the record length to a smaller value.
Clone the waveform between two cursors, and
output it through the built-in generator.
Save the waveform between two cursors
Save to internal memory. When selecting
an object, a message will appear in the
Internal
screen center, show the information of the
selected object.
Save the waveform onto a USB memory
device
Insert a USB memory device into the port
on the front panel. If the icon
on the top right of the screen, the USB
memory device is installed successfully. If
Externa
the USB memory device cannot be
l
recognized, format the USB memory
device according to the methods in "USB
disk Requirements" on P68. The name is
default as current system date and time.
The cloned waveform will be saved onto
the USB memory device as a OTA file.
(Generator is available and internal storage is selected)
Output the waveform stored in the selected object.
77
Time
Frequency
Length
appears
Advertisement
Table of Contents
