User Interface Introduction
31
30
29
28
27
26
25
Figure 3-4 Illustrative Drawing of Display Interfaces
1. Waveform Display Area.
2. Run/Stop (touchable on touchscreen) (see "How to Use Executive
Buttons" on P97)
3. The state of trigger, including:
Auto: Automatic mode and acquire waveform without triggering.
Trig: Trigger detected and acquire waveform.
Ready: Pre-triggered data captured and ready for a trigger.
Scan: Capture and display the waveform continuously.
Stop: Data acquisition stopped.
4. Click to auto set.
5. The two blue dotted lines indicates the vertical position of cursor
measurement.
6. The pointer indicates the trigger position in the record length.
7. The T pointer indicates the horizontal position for the trigger.
8. It shows present triggering value and displays the site of present window in
internal memory.
9. Touchable icon is to enable (
controls.
10. It shows setting time (see "Config" on P80).
11. It indicates that there is a USB disk connecting with the oscilloscope.
3.Junior User Guidebook
1
3
4
5
2
24
23
22
7
9
6
5
8
) or disable (
9
11
10
12
13
14
15
16
17
18
19
20
21
) the touchscreen