Table of Contents
Advertisement
CH1 CH2
CH3 CH4
Meas Type
(left menu)
Remove
Remove
Remove All
Snapsh
ot
Source
Gating
Set
Statistics
Measure
Only if the waveform channel is in the ON state, the measurement can be
performed. The automatic measurement can not be performed in the
following situation: 1) On the saved waveform. 2) On Waveform Math
waveform. 3) On the Video trigger mode.
On the Scan format, period and frequency can not be measured.
Measure the period, the frequency of the CH1, following the steps below:
1. Push the Measure front panel button to show the Measure menu.
2. Select Add in the bottom menu.
3. In the left Type menu, turn the M knob to select Period.
4. In the right menu, select CH1 in the Source menu item.
5. In the right menu, select Add. The period type is added.
6. In the left Type menu, turn the M knob to select Frequency.
7. In the right menu, select CH1 in the Source menu item.
8. In the right menu, select Add. The frequency type is added.
The measured value will be displayed at the bottom left of the screen
4.Advanced User Guidebook
Source
Select the source
Add the selected measure types (shown
Add
at the left bottom, you could only add 8
types at most)
Select the types need to be deleted.
The selected type and source are shown
in the Remove menu on the right.
Remove the selected measure type
Remove all the measures
Show all the measures of the snapshot
ON
source
OFF
Turn off the snapshot
CH1
CH2
Select the snapshot source
CH3
CH4
Screen
Select "Screen" or "Cursor" to set the cur
Cursor
sor range
ON
select "ON" or "OFF" for measurement v
OFF
alue statistics
Reset
Restart statistics on statistics
87
Advertisement
Table of Contents
