Table of Contents
Advertisement
● FRA (Frequency Response Analysis)
If there is a built-in arbitrary function generator (optional), you can use the
frequency response analysis. Refer to "Frequency Response Analysis" on
page 107.
How to Update your Instrument Firmware
Use the front-panel USB port to update your instrument firmware using a USB
memory device.
USB memory device requirements: Insert a USB memory device into the
USB port on the front panel. If the icon
screen, the USB memory device is installed successfully. If the USB memory
device cannot be detected, format the USB memory device according to the
methods in "USB disk Requirements" on P68.
Caution: Updating your instrument firmware is a sensitive operation, to
prevent damage to the instrument, do not power off the instrument or remove
the USB memory device during the update process.
To update your instrument firmware, do the following:
1. Push the Utility button, select Function in the bottom menu, select
Configure in the left menu, select About in the bottom menu. View the
model and the currently installed firmware version.
2. From a PC, visit the website and check if the website offers a newer
firmware version. Download the firmware file. The file name must be
Scope.update. Copy the firmware file onto the root directory of your USB
memory device.
3. Insert the USB memory device into the front-panel USB port on your
instrument.
4. Push the Utility button, select Function in the bottom menu, select Update
in the left menu.
5. Press Open in the lower menu to display a list of folders for USB storage
devices.Rotate the M knob to select a folder, and press Open in the menu
below to enter this folder.After entering the folder where the firmware file is
located, select the firmware file.
6. In the bottom menu, select Start, the messages below will be shown.
4.Advanced User Guidebook
appears on the top right of the
85
Advertisement
Table of Contents
