Connect Through A Router - Owon XDS4000 Series User Manual

Figure 7-3 Set the network parameters of the Oscilloscope Software
(4) Set the network parameters of the oscilloscope. In the oscilloscope, push
the Utility button. Select Function in the bottom menu. Select LAN Set in the
left menu. In the bottom menu, set the Type item as LAN, and select Set. In
the right menu, set IP and Port to the same value as the "Ports-settings" in the
software in step (3). Select Save set in the bottom menu, it prompts "Reset to
update the config". After resetting the oscilloscope, if you can get data normally
in the oscilloscope software, the connection is successful.
Figure 7-4 Set the network parameters of the oscilloscope

Connect through a router

(1) Connection. Use a LAN cable to connect the oscilloscope with a router, the
LAN port of the oscilloscope is in the right side panel; the computer should be
connected to the router too.
(2) Set the network parameters of the computer. Since the oscilloscope can
not support obtaining an IP address automatically, you should assign a static
IP address. The Default gateway and Subnet mask should be set according to
7.Communication with PC
118