Aiming Duration Time - Wasp WWS650 Product Reference Manual

Aiming Duration Time

Specifies the frame of time the aiming pointer remains on after decoding a label, when in trig-
ger single mode. The range for this setting is from 1 to 255 seconds in 1-second increments.
Follow these instructions to set this feature:
1. Determine the desired setting.
2. Pad the result with leading zeroes to yield three digits. For example: 0 = 000, 5 = 005, 20
= 020, etc.
3. Go to page 80
ming Mode.
4. Scan the bar code: SELECT AIMING DURATION TIME SETTING.
5. Scan the appropriate three digits from the keypad in
the duration which was determined in the steps above. You will hear a two-beep indication
after the last character.
If you make a mistake before the last character, scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the beginning.
NOTE
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming Mode.
This completes the procedure. See
Table 40. Aiming Duration Time Setting Examples
STEP ACTION
1 Desired Setting
2 Pad leading zero(es)
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT AIMING DURATION TIME SETTING
Scan Three Characters From
5
Appendix D, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
Product Reference Guide
and scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Program-
Table 40
EXAMPLES
1 Second
'0', '0' and '1'
Appendix D,
for some examples of how to set this feature.
90 Sec. (1.5 min.) 180 Sec. (3 min.)
001 090
'0', '9' and '0'
Keypad, that represent
255 Seconds (4.25
min.)
180
'1', '8' and '0' '2', '5' and '5'
255
259