Source Radio Address Delimiter Character - Wasp WWS650 Product Reference Manual

Enter/Exit Programming Mode

Source Radio Address Delimiter Character

This option specifies the delimiter character to be placed between the label data and radio
address when address stamping is enabled.
This feature only applies if
page 219 is enabled.
NOTE
$CBTAD
Set Source Radio Address Delimiter Character
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
220
"Source Radio Address Transmission"
DEFAULT
To configure this feature, scan the ENTER/EXIT PROGRAM-
MING MODE bar code above, then the bar code at left fol-
lowed by the digits from the Alphanumeric characters in
Appendix D Keypad
acter(s). End by scanning the ENTER/EXIT bar code again.
~
00 = No Delimiter Character
RF Address Stamping
on
representing your desired char-
CANCEL
Wasp WWS650