Wasp WWS650 Product Reference Manual page 25

Linking to a PC in Client Mode (BT Master Mode)
The reader can optionally be linked in client mode to a Bluetooth-enabled PC with the serial
port profile. To do this, follow these steps:
1. Ensure the PC or terminal can network with Bluetooth devices and that it is powered on.
2. Ensure that a COM port is assigned under Services within the Bluetooth setup menu.
3. Create a Link label that contains the address of the PC Bluetooth adapter.
The Bluetooth address can be found under "Properties" within in the Bluetooth setup
menu.
NOTE
The link label is a Code 128 function 3 label with the following format:
<FN3 char>LnkB<12 character Bluetooth address>
4. Scan the link label you created in step 3.
Linking to a PC in HID mode
1. Install any drivers provided with the Bluetooth adapter.
2. Scan the
Link to PC in HID
3. Use the host computer's Bluetooth manager to "Discover new devices" and select "Wasp
Scanner." If you receive an error message, it may be necessary to disable security on the
device.
4. Use a text editor to see incoming data on the port designated by the computer's Bluetooth
manager.
Once the reader has been connected to an Apple® iPad, smart phone, or laptop via
HID mode, you can toggle the virtual keyboard on the host by double pressing the
NOTE
trigger within 0,5 second. This feature is only supported on Apple devices.
Power Off
Shuts off power to the BT handheld until the next trigger pull. This function only applies to the
BT model.
Product Reference Guide
label below.
Link to PC in HID
Virtual Keyboard
PowerOff

15