Wasp WWS650 Product Reference Manual page 251

Enable Character
Specifies the value of the RS-232 host command used to enable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected.
Setting to previously defined characters such as XON, XOFF, or host commands conflicts
with normal operation of these characters. 8-bit data is not recognized when the option
Data Bits
NOTE
To set this feature:
Determine the desired character or value.
not used (not available).
1. Determine the desired character or value.
2. Use the ASCII Chart
the desired character/value.
3. Go to page 36
ming Mode.
4. Scan the bar code: SELECT ENABLE CHARACTER SETTING.
5. Scan the appropriate two alphanumeric characters from the keypad in
pad, that represent the desired character/value in step 2 above. The second character will
cause a two-beep indication.
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming Mode.
This completes the procedure. See
Table 31. Enable Character Setting Examples
STEP ACTION
1 Desired character/value
Hex equivalent from ASCII
2
Chart
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT ENABLE CHARACTER VALUE SETTING
Scan Two Characters From
5
Appendix D, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
Product Reference Guide
has been set as 7 Data Bits.
on the inside back cover of this manual to find the hex equivalent for
and scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Program-
Table 31
EXAMPLES
'6' and '5'
A setting of 0xFF indicates the Enable Character is
for some examples of how to set this feature.
'e' '}'
0x65 0x7D
'7' and 'D'
Appendix D, Key-
Enable Command
'E'
Not Used
0x45 0xFF
'4' and '5' 'F' AND 'F'
241