Plessey Set Length 2 - Wasp WWS650 Product Reference Manual

1D Symbologies

Plessey Set Length 2

This feature specifies one of the bar code lengths for
Length 2 is the maximum label length if in
fixed length if in Fixed Length on page 245
and full-ASCII shift characters. The length does not include start/stop characters.
The length can be set from 1 to 50 characters. A setting of 0 specifies to ignore this length
(only one fixed length).
Table 24 provides examples for setting Length 2. See
ting this feature.
Table 24. Plessey Length 2 Setting Examples
STEP ACTION
1 Desired Setting
2 Scan ENTER/EXIT PROGRAMMING MODE
3 Scan SELECT PLESSEY LENGTH 2 SETTING
Scan Two Characters From
4
Appendix D, Keypad
5 Scan ENTER/EXIT PROGRAMMING MODE
$CPLL2
Select Plessey Length 2 Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again
at the beginning.
Product Reference Guide
EXAMPLES
00 (Ignore This
Length)
'0' and '0'
50 = Length 2 is 50 Characters
DEFAULT
Plessey Length Control on page
Variable Length on page 245
Mode. Length includes the bar code's check, data,
page 245
07 Characters
'0' and '7'
~
Enter/Exit Programming Mode
Mode, or the second
for detailed instructions on set-
15 Characters 50 Characters
'1' and '5' '5' AND '0'
CANCEL
173.
175