Wasp WWS650 Product Reference Manual page 262

Label ID: Set Individually Per Symbology
To configure a Label ID individually for a single symbology:
1. Go to page 57
2. Select Label ID position as either BEFORE (Enable as Prefix) or AFTER (Enable as suffix) by
scanning the appropriate bar code in the section
Figure 7 for Label ID positioning options if multiple identification features are enabled.
3. Scan a bar code to select the symbology for which you wish to configure a custom Label ID
from the section
4. Determine the desired character(s) (you may choose up to three) which will represent the
Label ID for the selected symbology.
5. Turn to the ASCII Chart
digits associated with your choice of Label ID. For example, if you wish to select an equal
sign (=) as a Label ID, the chart indicates its associated hex characters as 3D. Turn to
Keypad, starting on page 293
determined. For the example given, the characters '3' and 'D' would be scanned. More
examples of Label ID settings are provided in
If you make a mistake before the last character, scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the beginning.
NOTE
6. Scan the ENTER/EXIT bar code to exit Label ID entry.
7. Scan the ENTER/EXIT bar code once again to exit Programming Mode.
This completes the steps to configure a Label ID for a given symbology.
Figure 7. Label ID Position Options
Prefix
252
and scan the ENTER/EXIT bar code.
"Label ID Symbology Selection − 1D Symbologies"
on the inside back cover of this manual and find the equivalent hex
and scan the bar codes representing the hex characters
Label ID Aim ID
"Label ID Control"
Table 36.
Bar Code Data
OR
on page 57. Reference
on page 58.
Label ID Suffix
Wasp WWS650