Error Codes - Wasp WWS650 Product Reference Manual

Table 48 . Programming Mode Indications
Programming Mode - The following indications ONLY occur when the reader is in Programming Mode.
Label Program- A valid programming label has
ming Mode Entry been scanned.
Label Program-
ming Mode Rejec- A label has been rejected.
tion of Label
In cases where multiple labels
Label Program-
must be scanned to program one
ming Mode
feature, this indication acknowl-
Acceptance of
edges each portion as it is suc-
Partial Label
cessfully scanned.
Label Program- Configuration option(s) have been
ming Mode successfully programmed via
Acceptance of labels and the reader has exited
Programming Programming Mode.
Label Program-
ming Mode Can- Cancel label has been scanned.
cel Item Entry

Error Codes

Upon startup, if the reader sounds a long tone, this means the reader has not passed its auto-
matic Selftest and has entered FRU (Field Replaceable Unit) isolation mode. If the reader is reset,
the sequence will be repeated. The following table describes the LED flashes/beep codes asso-
ciated with an error found.
NUMBER OF
LED FLASHES/
BEEPS
1
2
6
12
Product Reference Guide
LED blinks continuously
ERROR
Configuration
Interface PCB
Digital PCB
Imager
Reader sounds four low fre-
Reader sounds three times at
N/A lowest frequency & current vol-
ume.
Reader sounds one short beep at
N/A highest frequency & current vol-
Reader sounds one high fre-
N/A quency beep and 4 low frequency
beeps followed by reset beeps.
Reader sounds two times at low
N/A
frequency and current volume.
CORRECTIVE ACTION
Contact Helpdesk for assis-
tance
quency beeps.
ume.
275