Multiple Labels Ordering By Code Symbology - Wasp WWS650 Product Reference Manual

Multiple Labels Ordering by Code Symbology

This feature Specifies the transmission ordering by symbology type, when Multiple Labels per
Frame is enabled.Up to six symbologies can be selected. Zeroes must be added to pad the
string to 12 characters if not using all six symbologies.
The labels are ordered first as specified in the output mask. Labels present in the volume but
not specified will be transmitted as unspecified symbologies in random order as allowed by the
reading time sequence. For each label decoded in the volume the reader signals the standard
beeper and LED indications.
To specify the symbology order:
1. Determine the symbologies and order you want to specify.
2. Use Table 44 on page 263
3. Go to page 84
ming Mode.
4. Scan the bar code: "SELECT SYMBOLOGIES FOR MULTIPLE LABELS ORDERING".
5. Scan the appropriate two alphanumeric characters from the keypad in
pad, that represent the desired character/value in step 2 above.
6. Scan zeroes if needed to make a 12-character string.
7. When finished, scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming
Mode.
This completes the procedure. See
Table 43. Multiple Labels Ordering by Code Symbology Examples
STEP ACTION
1 Desired symbology
Hex equivalent from ASCII
2
Chart
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT SYMBOLOGIES FOR MULTIPLE LABELS ORDERING
Scan Two Characters From
5
Appendix D, Keypad
RESULT
6 Scan ENTER/EXIT PROGRAMMING MODE
Table 44 on page 263
262
to find the
and scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Program-
Table 43
EXAMPLES
Code 39
'2' and '4'
0x240E0C4E0000
shows the hex value associated with each symbology.
hex values for up to six symbologies.
for some examples of how to set this feature.
Data Matrix
24 0E
'0' and 'E'
Appendix D, Key-
Code 128 Aztec
0C 4E
'0' and 'C' '4' and 'E'
Wasp WWS650