Wasp WWS650 Product Reference Manual page 263

Table 36 . Label ID Examples
STEP ACTION
1. Scan the ENTER/EXIT bar code
Determine placement of the
Label ID characters BEFORE or
AFTER with regard to scanned
2.
data using Label ID
Control, starting on page
57
Scan the bar code selecting the
symbology type you wish to
designate label ID characters
for using Label ID
3.
Symbology Selection − 1D
Symbologies, starting on
page 58 .
Custom Label ID example
4.
(desired characters):
Find hex equivalents from the
ASCII Chart (inside back
cover), then scan in these
digits/characters using the bar
codes in the section:
Keypad, starting on page
5.
293 . If you make a mistake
before the last character, scan
the CANCEL bar code to abort
and not save the entry string.
You can then start again at the
beginning.
6. Scan the ENTER/EXIT bar code
Scan the ENTER/EXIT bar code
7.
once again
Result:
Product Reference Guide
EXAMPLES
(Scanner enters Programming Mode)
Enable as Prefix Enable as Suffix Enable as Prefix
DataBar
Code 39
Omnidirectional
D B * = C 3
44 42 2A 3D 43 33
(Scanner exits Programming Mode)
DB*[bar code [bar code
data] data]=C3
Interleaved 2 of 5
+
2B
(Scanner exits Label ID entry)
+[bar code data]
Enable as Suffix
Code 32
P H
50 48
[bar code data]PH
253