Scanning Features; Scan Mode - Wasp WWS650 Product Reference Manual

Scanning Features

Scan Mode

This mode is associated with typical handheld reader operation. Selects the scan operating
mode for the reader. The following selections are valid for all models:
When the trigger is pulled, scanning is activated until one of the following occurs:
Trigger Single:
• Scanning Active Time
• a label has been read
• the trigger is released
Trigger Hold Multiple:
trigger is released or
ning. Double Read Timeout
mode.
Trigger Pulse Multiple:
Active Time has elapsed or the trigger has been released and pulled again.
out prevents undesired multiple reads of the same label while in this mode.
The reader flashes on and off regardless of the trigger status. Flash rate is controlled
Flashing:
by Flash On Time and
Flash is OFF scanning is deactivated.
No trigger pull is required to read a bar code. Scanning is continually on. If the trig-
Always On:
ger is pulled, the reader acts as if it is in Trigger Single Mode.
undesired multiple reads of the same label while in this mode.
No trigger pull is required to read a bar code. Scanning is turned on automatically
Stand Mode:
when an item is placed in the reader's field of view.
If you are using a SMART STAND, Stand Mode is turned on automatically when the scanner
is positioned into the stand and, if the trigger is pulled, the reader acts as if it is in single
read mode.
NOTE
Double Read Timeout
256
has elapsed
When the trigger is pulled, scanning starts and the product scans until the
Scanning Active Time
prevents undesired multiple reads of the same label while in this
When the trigger is pulled, continuous scanning is activated until
Flash Off Time. When Flash is ON the imager reads continuously; when
prevents undesired multiple reads while in this mode.
has elapsed. Reading a label does not disable scan-
Double Read Timeout
Scanning
Double Read Time-
prevents
Wasp WWS650