System and Network Layouts
Stand Alone Layout
Connecting the Base when Security Pin is Enabled
When connecting the Base to a system that has a custom Security Pin enabled, follow the steps
below in the order shown:
1. Power down the host system.
2. Connect the appropriate interface cable into the Base
3. Place the reader in the Base.
4. Power up the host. The reader will link to the Base
5. When the host completely powers up, a new custom Security Pin Code may be sent to the
reader and Base, depending on host configuration. Contact Wasp Technical Support for
more information.
If you want to change security settings or set up a PIN, see
starting on page 221.
NOTE
Product Reference Guide
Host
Reader
Base Station
as
shown.
"BT Security Mode"
13