Pdf417 Set Length 1 - Wasp WWS650 Product Reference Manual

Symbology Selection

PDF417 Set Length 1

Specifies one of the bar code lengths for
minimum label length if in
Mode. Length includes the bar code's data characters only. Characters can be set from 0001 to
2,710 characters (pad with zeroes) in increments of 01. Any value greater than 2,710 will be
considered to be 2,710.
See page 245 for detailed instructions on setting this feature.
$CP4L1
Select PDF417 Length 1 Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
Product Reference Guide
PDF417 Length Control on page
Variable Length
0001 = Length 1 is 1 Character
DEFAULT
Mode, or the first fixed length if in Fixed Length
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by the digits from the Alphanumeric
Appendix D, Keypad
characters in
your desired character(s). End by scanning the ENTER/
EXIT bar code again.
~
Enter/Exit Programming Mode
192. Length 1 is the
representing
CANCEL
193