Stand Mode Off Time - Wasp WWS650 Product Reference Manual

Stand Mode Off Time

This feature specifies the amount of time reader illumination stays off after pulling the trigger
when in Stand Mode. The configurable range is 01 to 32 by 01 in increments of 500ms (500ms
to 16 seconds).
Follow these instructions to set this feature:
1. Determine the desired setting.
2. Pad the result with leading zeroes to yield two digits. For example: 2 = 02, 5 = 05, 20 =
20, etc.
3. Go to page 77
ming Mode.
4. Scan the bar code: Set Stand Mode Illuminator Off Time.
5. Scan the appropriate two digits from the keypad in
setting which was determined in the steps above. You will hear a two-beep indication after
the last character.
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming Mode.
This completes the procedure. See
Table 38. Stand Mode Off Time
STEP ACTION
1 Desired Setting
2 Pad leading zero
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT STAND MODE OFF TIME
Scan Two Characters From
5
Appendix D, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
Product Reference Guide
and scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Program-
Table 38
EXAMPLES
'0' and '1'
Appendix D,
for some examples of how to set this feature.
500 ms 1 Second
01 02
'0' and '2'
Keypad, that represent the
5.5 Seconds 16 Seconds
11
'1' and '1' '3' and '2'
32
257