Reading Parameters
Stand Operation
Specifies the behavior of the reader when stationary in a stand. There are two conditions which
cause the reader to switch to Stand Mode:
1. The reader is manually configured to switch to Stand Mode or when inserted into the spe-
cial Stand support which automatically enables the Stand Mode.
2. The reader is placed into the cradle of the base station (cordless models only).
Below are further options concerning Stand Operation.
Ignore Autorecognition.
Change to Stand Mode.
placed in the stand.
Automatically switches the reader to Flash Mode when the reader is placed in
Change to Flashing.
the stand.
Change to Always On.
placed in the stand
$CSMSD01(CR)
Change to Stand Mode
$CSMSD03(CR)
Change to Flashing
Product Reference Guide
Disables mode switching when the reader is placed in a stand.
Automatically switches the reader to Stand Mode when the reader is
Automatically switches the reader to Always On mode when the reader is
.
Enter/Exit Programming Mode
$CSMSD00(CR)
Do Not Change Mode
DEFAULT
$CSMSD02(CR)
Change to Always On
75