Aiming Duration Timer - Wasp WWS650 Product Reference Manual

Enter/Exit Programming Mode

Aiming Duration Timer

Specifies the frame of time the aiming pointer remains on after decoding a label, when in trig-
ger single mode.The range for this setting is from 1 to 255 seconds in 1-second increments.
See page 259 in "References" for a description of this feature.
DEFAULT
LSTM
Set Aiming Duration Timer
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
80
LSTM00
Aiming Off After Decoding
To configure, scan the ENTER/EXIT PROGRAMMING
MODE bar code above, then the bar code at left followed
by the digits from the Alphanumeric characters in
Appendix D, Keypad
character(s). End by scanning the ENTER/EXIT bar code.
~
Scanning Features
representing your desired
CANCEL
Wasp WWS650