Interface Selection; Setting The Interface - Wasp WWS650 Product Reference Manual

Interface Selection

Upon completing the physical connection between the reader and its host, proceed to Table 1
starting on page 16
232, Keyboard Wedge, USB, etc.). Scan the appropriate bar code in that section to configure
your system's correct interface type.

Setting the Interface

Scan the programming bar code from this section which selects the appropriate interface type
matching the system the reader will be connected to. Next, proceed to the corresponding sec-
tion in this manual (also listed in
tures associated with that interface.
Unlike some programming features and options, interface selections require that
you scan only one programming bar code label. DO NOT scan an ENTER/EXIT bar
code prior to scanning an interface selection bar code.
Some interfaces require the scanner to start in the disabled state when powered up.
NOTE
If additional scanner configuration is desired while in this state, pull the trigger and
hold it for five seconds. The scanner will change to a state that allows programming
with bar codes.
Table 1. Available Interfaces
RS-232
RS-232 standard interface
$P,HA12,P(CR)
Select RS232-WN
RS-232 for use with OPOS/UPOS/JavaPOS
$P,HA47,P(CR)
Select USB-COM-STD
a. Download the correct USB Com driver from www.waspbarcode.com
16
to select the interface type the reader is connected to (for example: RS-
Table 1 on page
a
16) to configure any desired settings and fea-
Select RS232-STD
RS-232 Wincor-Nixdorf
$P,HA13,P(CR)
Select RS-232 OPOS
USB Com to simulate RS-232 standard interface
FEATURES
Set RS-232
Interface
Features
starting on
page 25
Wasp WWS650