Bt Security Features; Bt Security Mode - Wasp WWS650 Product Reference Manual

Bluetooth-Only Features
On the BT system, it is possible to set a (configurable) PIN code to authenticate/connect BT
devices, and encrypt the data.
The BT PIN code can be enabled and configured by reading the bar codes in the following sec-
tions.
If you are using a BT scanner directly connected to a host through a BT dongle, verify that
the scanner and the BT driver used by the dongle share the same PIN code and the same
security level. Otherwise the connection cannot be established.
NOTE
Follow these steps to set the PIN code for a scanner:
1. Enable BT Security Mode by scanning the "Enable" bar code below.
2. Select a PIN code length of either 4 or 16 characters by scanning the appropriate bar code
in "Select PIN Code Length"
3. Scan the relevant bar code from
numeric characters from the keypad in
See page 265 in "References" for more detailed information and examples for this feature.

BT Security Mode

This feature enables/disables authentication and encryption of the BT link. Use the feature
PIN Code" on page 222 to specify the length and digits in the PIN code used to authenticate the
BT Link.
Changing the security mode setting will unlink the devices. If the Automatic Configuration
Update is set to the default "Enabled" setting, the devices must only be relinked. If the
Automatic Configuration Update is set to "Disabled," the Security Mode setting must also
NOTE
be updated in the Base Station (contact Technical Support). After the Base Station has been
updated, the devices must be relinked.
DEFAULT
$CBTSE01(CR)
BT Security Mode = Enable
Product Reference Guide

BT SECURITY FEATURES

on page 222.
"Set PIN Code"
Appendix D Keypad
Enter/Exit Programming Mode
on page 222, then scan the desired alpha-
to set the PIN code.
$CBTSE00(CR)
BT Security Mode = Disable
"BT
221