Maxicode Length Control; Maxicode Set Length 1 - Wasp WWS650 Product Reference Manual

Enter/Exit Programming Mode

Maxicode Length Control

This feature specifies either variable length decoding or fixed length decoding for this symbol-
ogy.
For variable length decoding, a minimum and maximum length may be set.
Variable Length:
For fixed length decoding, two different lengths may be set.
Fixed Length:
DEFAULT
$CMXLC01(CR)
Maxicode Length Control = Fixed Length
Maxicode
Set Length 1
Specifies one of the bar code lengths for
minimum label length if in
Mode. Characters can be set from 0001 to 0145 characters in increments of 0001 (pad with
zeroes).
See page 245 for detailed instructions on setting this feature.
$CMXL1
Select Maxicode Length 1 Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
190
Maxicode Length Control on page
Variable Length
0001 = Length 1 is 1 Character
DEFAULT
$CMXLC00(CR)
Maxicode Length Control = Variable Length
Mode, or the first fixed length if in Fixed Length
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by the digits from the Alphanumeric
Appendix D, Keypad
characters in
your desired character(s). End by scanning the ENTER/
EXIT bar code again.
~
190. Length 1 is the
representing
CANCEL
Wasp WWS650